Transmission removal, replacement, and installation. Learn how to remove a transmission so you can replace your clutch or flywheel, or so you can rebuild your transmission and install a new one in your car or truck.
In this video I show you the 10 simple steps on how to replace a transmission. I am doing this on a rear wheel drive 98 Mustang but the process is very similar on other rear wheel drive, front wheel drive, and even automatic cars and trucks. Each detailed step will allow you to learn how to remove a transmission yourself so you can replace a clutch, flywheel, rear main seal, throw out bearing, pilot bearing, or just swap transmissions.
Transmission Removal Checklist Download (FREE):
How to Replace a Clutch and Flywheel:
Extendable Ratchet Set:
Transmission Jack:
12 Ton Jack Stands:
Ramps:
Dust Mask:
Dust Filters:
Flex-Head Ratchet:
Torque Wrench:
Ratcheting Wrench Set:
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Week**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
To answer the most common questions in the comments section:
1.) Quality videos like this take a lot of time to produce. This and the next took me over 300hrs.
2.) Follow me on Instagram “ChrisFixit” for daily updates and tips and tricks.
3.) The exhaust on the car is the performance exhaust, just used on the track.
4.) The speedometer is fine… it spun all the way around at the last drift event and I havent had a chance to take the gauge cluster out and push it back to the other side of the peg.
5.) The other red Mustang is from this video: https://www.youtube.com/watch?v=N-exs1iMLFU
Does anyone know what to do if my clutch isnt engaging?
Someone help my clutch fork is loose and the wire has slack, when I hit the clutch it’s soft asd
“Just take a prybar”…… i’ve been hamering on that sucker for days now😂😂😂😂😂
When replacing a trans, or getting a used trans, what else should I replace/ buy?